Conditions Of Use Of CNC Lathes

The normal use of CNC lathes must meet the following conditions, the power supply voltage fluctuation at the position of the machine tool is small, the ambient temperature is less than 30 degrees of illumination, and the relative temperature is less than 80%.
Environmental requirements
The position of the machine tool should be far away from the vibration source, should avoid the influence of direct sunlight and thermal radiation, and avoid the influence of moisture and airflow. If there is a vibration source near the machine tool, an anti-vibration groove should be provided around the machine tool. Otherwise, it will directly affect the machining accuracy and stability of the machine tool, and will make the electronic components contact poorly, fail, and affect the reliability of the machine tool.
Power requirements
Generally, CNC lathes are installed in machining workshops, which not only have large changes in ambient temperature, poor use conditions, but also have many kinds of electromechanical equipment, resulting in large fluctuations in the power grid. Therefore, the location of the CNC lathe needs to be strictly controlled by the power supply voltage. Supply voltage fluctuations must be within the permissible range and remain relatively stable. Otherwise, it will affect the normal operation of the numerical control system.
Temperature conditions
The ambient temperature of the CNC lathe is less than 30 degrees of illumination, and the relative temperature is less than 80%. Generally speaking, the CNC electric control box is equipped with an exhaust fan or air cooler inside to keep the electronic components, especially the central processing unit, working temperature constant or the temperature difference change is small. Excessive temperatures and humidity will lead to reduced life of control system elements and increased failures. Increased temperature and humidity, as well as increased dust, can bond the integrated circuit board and cause short circuits.
Standardize the use of machine tools
When using the machine tool, the user is not allowed to change the parameters set by the manufacturer in the control system. The setting of these parameters is directly related to the dynamic characteristics of the individual components of the machine tool. Only the clearance compensation parameter values can be adjusted according to the actual situation.
The user cannot change the machine tool accessories at will, such as using a hydraulic chuck beyond the specifications of the manual. When setting up accessories, manufacturers fully consider the matching of various link parameters. Blind replacement causes mismatch of various link parameters, and even causes unestimated accidents.
The pressure of using hydraulic chuck, hydraulic knife holder, hydraulic tailstock and hydraulic cylinder should be within the allowable stress range and cannot be arbitrarily increased.